Job Description

Location
Site, Qatar
Experience
12
Job Type
Recruitment

Roles and Responsibilities:

1.Responsible for detailed engineering respective to his/her discipline.


2.Responsible for the review of engineering deliverables corresponding to his/her discipline.


3.Assist in the review and evaluation of Engineering Subcontractors and Packaged Vendors for pre-qualification.


4.Contribute to the Engineering Scope Matrix (Split of Responsibilities Matrix) with respect to his/her discipline.


5.Ensure correctness and completeness of engineering deliverables as per Qatar Statutory Regulations, Project Specifications, Material Requisitions, Approved Technical Exception/Deviation List, Datasheets, Standard Drawings, Client Engineering Specifications, Contractual requirements and International Codes and Standards.


6.Review all design basis, data sheet, specification, calculations and drawings from Engineering Subcontractor and Packaged Vendors in line with item-5, Order of Precedence.


7.Perform Inter-Discipline Check (IDC) on documents and drawings, as applicable, in order to minimize the number of revisions and to ensure compliance with the Project Planning Schedule prior to client submission.


8.Submit the reviewed/commented documents to Project Engineering Manager through Workflow Adept software.


9.Ensure that comments, clarifications and queries from Client are promptly attended to with Comments Resolution Sheet (CRS) during the next revision submission


10.Participate in discussions with Client, Engineering Subcontractor and Vendors for technical queries and clarifications respective to his/her discipline in order to comply the client technical and contractual requirements.


11.Participate in FEED Verification, Design Review and Safety Study Workshops, and Engineering Audit during the execution of EPIC projects.


12.Apply Lessons Learned' from previous projects and that received from Clients and Sub-Contractors.


13.Prepare the initial list of Material Criticality Rating in line with Client Procedure for Material and Criticality Rating for Inspection Level and participate in the workshop along with Client and Engineering Subcontractor, as required.


14.Provide input to Procurement and Subcontract Departments for any technical requirements for all issued RFQs / MRs in the Project.


15.Prepare Vendor Data Transmittal Addendum Sheets for Technical Bid Evaluation (TBE).


16.Support CONTRACTOR Project and Construction Teams for Field Design Changes and Field Engineering Queries, as required.


17.Participate in the evaluation for verifying pre-qualification of TPCA/TPCI for conducting factory inspection after manufacturing.


18.Provide technical input to stores and ware house for material handling and preservation procedures.


19.Provide Inspection Release Note (IRN) to the vendors after completion of FAT Punches based on written Client approval.


20.Conduct site appraisal and probability studies for project upgradation.


21.Conduct system walk-down and Pre-Start-up Safety Review (PSSR) walk-down along with Client prior to performing commissioning activities.


22.Work with Telecom, PAGA system, CCTV system, Security Access and Attendance system, Meteorological system, Microwave line-of-sight radio, Fence Intrusion Detection system, OTN system, DTS system, TETRA radio system, Aeronautical radio system, Marine radio system, Telephone system and Structured cabling system


23.Assist the Commissioning Task Force for engineering issues respective to his/her discipline.


24.Provide Technical Services to Operations (P&M), as required.


25.Participate in ASME / ISO 9001 Accreditation / Certification Audit Programs, as required.


26.Support training and development of junior personnel.

Qualifications/Experience:

Bachelor Degree in Engineering or Equivalent, in the respective disciplines Minimum 10 - 12 years' experience in engineering related to oil and gas, Petrochemical and infrastructure projects. Knowledge of International Codes and Standards and Design Software. Proficiency in MS Office Packages - Excel, Word, Power Point.












Skills
Training And Development, Project Planning, Inspection, Roller, Visio, Design Software, Compliance, Workflow, Excel, Communication Skill, Ms Office, Drawings