• Responsible for alignment and clamping of line pipes accurately using internal line up clamp in the line-up station on the barge before the root pass welding

• Prepare internal line up clamps with the correct size of copper back-up shoes, pneumatic and electrical connection, buckle detector, X-ray stopper, etc. to suit the internal diameter of the pipes to be laid, prior to start of pipe laying.
• Check the ovality and seam orientation of the pipes being aligned and instruct the line-up operator to orient and move the pipes to get an acceptable fit-up.
• Align the two pipes in the line-up station using the internal line-up clamp to get the best fit-up and suitable for welding the root pass.
• Carry out measurements of Hi-Lo around the pipe and report to the QC inspector.
• Inspect the clamp and clean the copper backup shoes after every joint and change the copper backup shoes, as and when necessary.
• Carry out routine preventive maintenance on the internal lineup clamp to keep it in good condition to avoid any breakdown.
• Report any problems found during the inspection and operation of the clamp to the welding supervisor.
• Take necessary action to avoid potential hazards.
• Compliance with Company procedures and HSE standards.

• Mainly working offshore

• Report to the Welding Superintendent/Supervisor
• Work independently under supervision
• Communicate regularly with the supervisors and Barge Supervision
• Liaise periodically with the offshore operation at base

• Work within a well-structured environment with clear reporting lines and defined accountabilities
• Be aware of occupational hazards and follow safe work practices
• Guided by Company policies & procedures, Integrity Policy & Code of Conduct and HSE standards

Bayt