Job Description

CNC

Given below are a CNC job description and the major tasks, duties, and responsibilities of the role:

This is an alloy wheel which has been put on a lathe cnc machine and part of or the entire painted surface of the wheel machined off to leave a shiny alloy finish. A small part of the actual alloy is machined off to create this finish. It is then lacquered or powder clear coat over to prevent corrosion.

When Alloy Wheel diamond cutting CNC machine are used to refinish alloy wheels, the procedure is quite straightforward with simply 3 steps:

A

. Digitizing the typical wheel surface to produce the G-code for the machining profile. B

. Trial-run procedure.

C. Machining Procedure.

The digitizing probe is usually installed on the tool post of the Diamond Cut Alloy Wheel CNC lathe to record the rim profile before machining. To begin this process, the CNC operator sets up the starting and finishing positions for each alloy wheel. In most cases, the typical profile should be continuous pass along the spoke from center of the hub to the outside edge of the lip. Then, the digitized profile will be tested during the Trial-Run before the final machining process.

Duties:

1. Wheels should have done painting

2. Wheels must be straightened no vibration

3. Machine is working properly

4. Ensure housekeeping is maintained to the highest standards.

5. To prove out downloaded programs so they are in line with the correct timings in part of our quickly process with in the quality standards.

Requirements and qualification

Education and technical training certification.

High school diploma.

At least 3 years' experience in CNC machine operator

Employment certificates

25 - 35 years old

Any nationality

Job Type: Full-time